N5 Completely Automatic Plastering Machine

Inquiry Overview | Technical Parameters | Introduction | Working Principle | Features | Inquiry

N5 Completely Automatic Plastering Machine Spray Plastering Machine for Wall Keeping the air pump running for 2-5 minutes after turn on the machine (heating the grease lubrication to make the bicycle pump work normally), then fill the mixing hopper with water (to lubricate the hose), next to dismantle the hose and add material, adjust the water pressure, connect the hose to start work until the material from the dismantling place reach the normal scope.

N5-Plaster-machine

N5-Plaster-machine

  • ModelN5 completely automatic
    Voltage380/220V
    Power4KW
    Displacement volume6-85L/min
    Delivery pressure30bar
    Maximum delivery distance0-100m
    Maximum delivery height30m
    Allowed maximum diameter of material3mm
    Hopper volume120L
    Feeding modeCompletely automatic
    Weight of control case70kg
    Weight of delivery parts95kg
    Weight of hopper100kg
    Overall weight265kg
    CTN’s Dimension1750×850×1750mm

The Zhengzhou Sincola N5 Dry Ready-mix Plaster Machine is Keeping the air pump running for 2-5 minutes after turn on the machine (heating the grease lubrication to make the bicycle pump work normally), then fill the mixing hopper with water (to lubricate the hose), next to dismantle the hose and add material, adjust the water pressure, connect the hose to start work until the material from the dismantling place reach the normal scope.
When finishing work, the machine should be cleaned. Clean the material in the hopper with water through and out of the hose, until the clean water flow out. Then dismantle the hose, at last hung the hose vertically, clear the sand in the inner surface of the hose with clean water.
Remark: when you start the machine, the air pump should be started at first, then start the material; but when turn off the machine, you should stop the spraying first, then shut off the air pump, in case that the

Application Of Applications

All pumpable dry ready-mixed mortars or materials, such as Cement mortars, Lime plasters, Gy-psum plasters, Masonry mortars, Insulating plasters , Self-leveling floor screeds, etc.

  • Working Principle of Dry Ready-mix Plaster Machine

    The dry materials is supplied in sacks and filled into the large hopper.the low height of the N5 makes filling considerably easier.the materials is then transported by the agitator out of the hopper into the mixing pipe of the machine.the particular geometry of the agitator means the hopper can be emptied almost 100%.in the mixing area.the amount of water appropriate to the materials is supplied .depending on the mortar used.the amount of water can be separately regulated.the integrated water pump ensures the water pressure is always adequate.the mixing area is extremely large.this means the material is perfectly mixed and reaches the rotor/stator pump of the machine in an ideal condition .there it is then pumped at pressure through the mortar hose.the nozzle is connected in the end of mortar hose with compressed air.and then the mixed mortar is sprayed out evenly.the integrated mini compressor ensure the air pressure and consumption always adequate .as well as remote-control by air valve.attention for detail instruction .please follow the operation manual

  • Features Of Dry Ready-mix Plaster Machine

    1.The integrated machine with mixer, self-suck water pump, mini compressor and rotor/stator pump.
    2.The continuously mixing and pumping machine.
    3.Small and handy dimension and low weight, quickly and easily transport even in the most confined spaces.
    4.The rotor/stator pump ensures the material is pumped and sprayed out continuously and evenly.
    5.The machine always works with efficiency and silence.
    6.With air valve remote-control function.
    7.The machine consists of portable units, permitting easy to operate and take maintenance and easy to use in any circumstance.